EZ Reach Circuit Breaker Pulley

Used to access your breaker for larger batteries.

Includes:

• Steel wire loop
• Zip ties
• 3M cable clips

Installation Steps:

1. Drill through the center of the red breaker switch with a small drill bit, allowing you to pass through the steel wire. Secure by tightening the two Phillips screws.
2. Apply the product using the technique shown in the last photos. Running the zip ties through the loops will prevent them from slipping behind the battery, ensuring they remain easily accessible.

To guarantee optimal adhesion of the cable clips, follow these steps:

• Clean the surface with isopropyl alcohol.
• Heat up the 3M surface using a hairdryer or heat gun.
• When applying to the bike frame, press firmly for at least 10 seconds.

Please note: The circuit breaker shown is for installation demonstration purposes only and is not included with the product.